Recently started having an issue where the coils don't seem to be able to draw any juice in.
I've been priming the coils (originally Claptons but also SS316-0.6ohm) the same as always but now they seem to be drying out very quickly. After a few draws I start to get a slightly burnt taste and if I start to unscrew the cap, the little air bubbles suddenly pop up from the bottom of the coil and the flavour goes back to normal (cotton drying out I'm guessing).
It's like the coil is too tight against the bottom of the tank or the cap screws in further than it used to (damaged o-ring?), I can see the little air bubbles starting but they're stuck to the inlet on the coil and don't come free until I unscrew the cap.
Has anyone else had this problem?
I've tried several different coils from different packs and suppliers with no change, even if the top is only screwed on loosely.
I'm fairly new to vaping, sorry if any of my terminology is confusing or wrong.
Thanks in advance.
I've been priming the coils (originally Claptons but also SS316-0.6ohm) the same as always but now they seem to be drying out very quickly. After a few draws I start to get a slightly burnt taste and if I start to unscrew the cap, the little air bubbles suddenly pop up from the bottom of the coil and the flavour goes back to normal (cotton drying out I'm guessing).
It's like the coil is too tight against the bottom of the tank or the cap screws in further than it used to (damaged o-ring?), I can see the little air bubbles starting but they're stuck to the inlet on the coil and don't come free until I unscrew the cap.
Has anyone else had this problem?
I've tried several different coils from different packs and suppliers with no change, even if the top is only screwed on loosely.
I'm fairly new to vaping, sorry if any of my terminology is confusing or wrong.
Thanks in advance.