Dear all,
I am having a rather annoying issue with my Evic VTC Dual, which - to my opinion - could be rather easily fixed with a firmware upgrade.
I use multiple RTAs in SS TC mode whose resistances are rather close to each other. For that reason I have to frequently lock and unlock the resistances. My problem is that quite often the resistance does not really get unlocked on unlocking: If the resistance of the new coil is significantly higher than the one of the old coil, I am asked whether it's indeed a new coil. If the new resistance is significantly smaller the locked resistance is automatically adjusted and I don't even have to lock and unlock.
If the old and the new resistance are close to each other, however, the device keeps the old resistance even on un- and re-locking, i.e. when the device is turned on (after unlocking the old resistance) it reads the correct (measured) new resistance at room temp, but when I enter the menu to lock this resistance it jumps back to the previously locked resistance.
In such problematic cases as above I quite often have to use yet another (3rd) tank with a completely different resistance as an in-between step, i.e. go from 1.21 ohm to 0.6 and then to 1.3 because 1.21 to 1.3 is not possible. Is there any trick I am not aware of? If not, could you please explain to me why the unlocking of the resistance is not actually unlocking it and whether this can be fixed in an update?
Thanks in advance.
Best regards,
pi-xel
I am having a rather annoying issue with my Evic VTC Dual, which - to my opinion - could be rather easily fixed with a firmware upgrade.
I use multiple RTAs in SS TC mode whose resistances are rather close to each other. For that reason I have to frequently lock and unlock the resistances. My problem is that quite often the resistance does not really get unlocked on unlocking: If the resistance of the new coil is significantly higher than the one of the old coil, I am asked whether it's indeed a new coil. If the new resistance is significantly smaller the locked resistance is automatically adjusted and I don't even have to lock and unlock.
If the old and the new resistance are close to each other, however, the device keeps the old resistance even on un- and re-locking, i.e. when the device is turned on (after unlocking the old resistance) it reads the correct (measured) new resistance at room temp, but when I enter the menu to lock this resistance it jumps back to the previously locked resistance.
In such problematic cases as above I quite often have to use yet another (3rd) tank with a completely different resistance as an in-between step, i.e. go from 1.21 ohm to 0.6 and then to 1.3 because 1.21 to 1.3 is not possible. Is there any trick I am not aware of? If not, could you please explain to me why the unlocking of the resistance is not actually unlocking it and whether this can be fixed in an update?
Thanks in advance.
Best regards,
pi-xel